| Ground To Top Of Hood | 10.9ft in |
|---|---|
| B-Pin Height - Maximum Lift | 18ft in |
| Reach - Maximum Lift | 6.8ft in |
| Clearance At Maximum Lift | 11.3ft in |
| Wheel Base | 14.9ft in |
| Ground To Top Of Rops | 13.7ft in |
| Ground To Bumper Clearance | 3.1ft in |
| Ground To Center Of Axles | 3.2ft in |
| Maximum Overall Length | 40ft in |
| Net Power | 541hp |
| Rated Speed | 1700rpm |
| Displacement | 1105cu in |
| Torque Rise | 58% |
| Bore | 5.7in |
| Stroke | 7.2in |
| Emissions | U.S. EPA Tier 4 Final/EU Stage IV |
| Net Power - Sae J1349 | 541hp |
| Engine Model | Cat C18 ACERT |
| Gross Power - Iso 14396 | 580hp |
| Peak Power Speed | 1,500 rpm |
| Peak Torque @ (Speed) - Sae J1995 | 2104lb ft |
| Operating Weight | 116362lb |
| Transmission Type | Cat switched reluctance electric drive |
| Forward 1 (Virtual) | 4.3mph |
| Forward 2 (Virtual) | 7mph |
| Forward 3 (Virtual) | 13.8mph |
| Forward 4 (Virtual) | 20mph |
| Reverse 1 (Virtual) | 4.3mph |
| Reverse 2 (Virtual) | 7mph |
| Reverse 3 (Virtual) | 17.5mph |
| Bucket Capacities | 4.7-13 m3 (6.2-17 yd3) |
| Front | Fixed |
| Rear | Trunnion |
| Oscillation Angle | 13 degrees |
| Brakes | ISO 3450:2011 |
| Bucket Capacity Range | 4.7-13 m3 (6.2-17 yd3) |
| Operating Weight - Standard | 116362lb |
| Operating Weight - High Lift | 119618lb |
| Fuel Tank | 147gal |
| Diesel Exhaust Fluid Tank | 8.7gal |
| Engine Crankcase | 16gal |
| Transmission | 16gal |
| Note | All non-road Tier 4 Final/Stage IV diesel engines are required to use: The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less) or up to B20 |
| Cooling System - Jacket Water | 30gal |
| Cooling Systems - Power Train | 8gal |
| Raise | 8 s |
| Dump | 2.2 s |
| Lower Float Down | 3.5 s |
| Rack Back | 4.5 s |
| Total Hydraulic Cycle Time | 18.2 s |
| Lift/Tilt System - Circuit | EH-Positive Flow Control, Flow Sharing |
| Lift/Tilt System - Pump | Variable displacement piston |
| Tilt Cylinder - Stroke | 27in |
| Lift Cylinder - Bore | 8.7in |
| Lift Cylinder - Stroke | 41.3in |
| Tilt Cylinder - Bore | 8.7in |
| Steering System - Circuit | Pilot, load sensing |
| Steering System - Pump | Piston, variable displacement |
| Steering Cut Off Pressure | 4351 psi |
| Steering | ISO 5010:2007 |
| Air Conditioning | The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equi |
| Rops/Fops | ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards |
| Note (1) | The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. The measurement was conducted at 70 percent of the maximum engine cooling fa |
| Note (2) | Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment. |
| Note (3) | The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan sp |
